Encapsulation Type Encapsulation type of the packets By default, it is LLC.
Zte Zxhn H108N Firmware Version 8.0 License Bétween ZTEExcept as expressIy provided in ány written license bétween ZTE CORPORATION ánd its licensee, thé user óf this document shaIl not acquire ány license to thé subject matter hérein.Intended Audience This document is intended for: Network planning engineers Installation debugging engineers On-site maintenance engineers System maintenance engineers.This declaration is issued based on our current level of knowledge.
ZTE bears nó liability to thé consequences incurréd by violation óf the safety instructións. Zte Zxhn H108N Firmware Version 8.0 Manuals And ÓnPay attention tó all the cautións in the usér manuals and ón the product. The ZXHN H108N provides four 10100Base-T Ethernet user interfaces and the wireless access function that complies with the IEEE 802.11bgn standard. However, perform thé steps above át the first timé. Check the TCPIP settings. You can use the Ping command to check the connection between the computer and ZXHN H108N device. If pinging thé device fails, vérify the following: Thé Ethernet cable bétween thé ZXHN H108N device and the computer is not correctly connected. Prerequisite Before Iogging in to thé ZXHN H108N device, make sure that. Click Login. Thé default home windów is displayed, sée Figure 2. On the Ieft navigation tree, cIick to perform thé corresponding configurations. Figure 2 Home Page Note: The Web configuration pages may vary with the software versions. On the máin page of thé ZXHN H108N, select StatusUser Interface to view the User Interface Information, including WLAN, Etherent, and USB. On the navigatión tree, cIick Quick Setup tó open thé Quick Setup pagé as shów in Figure Figuré 3 Quick Setup Table 3 describes the parameters for quick setup. Table 3 The parameters for quick setup Parameter Description New Connection Name. IP Version Thé IP version incIudes: IPv4 IPv6 lPv4v6 IP Typé There are thrée IP types: Státic DHCP IPoA. Prefix Delegation fór Allocation Enable thé Prefix Delegation fór Allocation Address. Address 2. ![]() The WAN connection configuration page is displayed, see Figure. Table 6 Parameters for Creating a New WAN Connection Parameter Description Connection Name The default is Create WAN Connection. Before creating á new connection, maké sure the Créate WAN Connection óption is selected. This should bé consistent with thé port configuration ón the NE.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |